Juniper JN0-682 Practice Test Pdf Exam Material [Q29-Q45]

Juniper JN0-682 Practice Test Pdf Exam Material

JN0-682 Answers JN0-682 Free Demo Are Based On The Real Exam

NEW QUESTION # 29
What are three functions supported by the Contrail Command user interface? (Choose two.)

A. Integrated syslog collector
B. Onboarding of an IP fabric
C. Configuring management domains
D. Enabling VM-to-BMS bridging
E. Creating virtual network

Answer: A,C,E

NEW QUESTION # 30
Exhibit.

You are troubleshooting a connectivity issue across a VXLAN overlay network. In the exhibit, you are using the ping overlay command from a local VTEP residing on a OFX 5120 to a remote VTEP residing on a separate QFX5120.
What is the problem in this situation?

A. VXLAN VN1100 is not configured on the local VTEP
B. VXLAN VN1100 is not configured on both end points.
C. VXLAN VN1100 is not configured on the remote VTEP.
D. The VXLAN controller is down.

Answer: C

NEW QUESTION # 31
The configuration shown in the exhibit is intended to set up assisted replication but will not commit. Which action will create a valid configuration in this situation?

A. Change the replicator inet address to 192.168.100. 51.
B. Change the 10.0 address to 192.168.100.1 primary.
C. Delete replicator inet 192.168.100.1.
D. Change the replicator inet address to 192.168.100.101.

Answer: D

NEW QUESTION # 32
You are designing a network for a small data center.
In this scenario, which underlay protocol allows for the simplest implementation?

A. IGGP
B. OSPF
C. EBGP
D. MPLS

Answer: B

NEW QUESTION # 33
What is the purpose of the command shown in the exhibit?

A. To stop the reception of transit multicast traffic when there are no interested receives attached to the local VTEP
B. To disable the group2390.0.1 across the entire VXLAN.
C. To disallow IGMP request for the group 239.0.01 from host attached to the local VTEP
D. To stop the transmission of transit multicast traffic when there are no interested receives attached to a remote VTEP

Answer: D

NEW QUESTION # 34
An EVPN-signaled VXLAN overlay has been deployed in the network shown in the exhibit. An EVPN LAG has been configured to connect host1 to the network, and device leaf1 has been elected as the designated forwarder.
In this scenario, which statement is true?

A. The Ieaf3 device can utilize both leaf1 and Ieaf2 to forward unicast packets from host2 to host1.
B. The Ieaf3 device will only receive an advertisement to the LAG segment from leaf1.
C. Broadcast packets sent from host2 will not be forwarded to Ieaf2.
D. An ICCP control link must be configured between leaf1 and Ieaf2.

Answer: B

NEW QUESTION # 35
Exhibit.

The two data centers shown in the exhibit need to be connected using EVPN.
Which two statements are correct in this situation? (Choose two.)

A. Hosts in VLAN 10 can communicate with hosts in Data Center 2 using Layer 2.
B. Hosts in VLAN 202 can communicate using Layer 3 between data centers.
C. Hosts in VLAN 202 can communicate using Layer 2 between data centers.
D. Hosts in VLAN 10 can communicate with hosts in Data Center 2 using Layer 3.

Answer: C,D

NEW QUESTION # 36
Which two statements about the seamless EVPN-VXLAN stitching interconnect gateways are correct? (Choose two.)

A. All EVPN routes types are forwarded among interconnect gateways in a full-mesh manner.
B. IBGP is recommended for VXLAN stitching overlays.
C. The interconnect gateway can reside on the super spine layer of a multi-POD data center.
D. Interconnect gateways will rewrite the route target, route distinguisher. and ESI values for each stretched virtual network.

Answer: A

NEW QUESTION # 37
Exhibit.

A VXLAN has been created between devices leaf1 and Ieaf3.
Referring to the exhibit, which statement is true?

A. Traffic sent from host1 to host2 will be tagged with VLAN ID 100 when exiting Ieaf3.
B. Traffic sent from host1 to host2 will be tagged with VLAN ID 200 when exiting Ieaf3.
C. Traffic sent from host1 to host2 will be dropped on leaf1.
D. Traffic sent from host1 to host2 will be dropped on Ieaf3.

Answer: A

NEW QUESTION # 38
A customer notices that all traffic is traveling over a single link within their partially meshed IP Fabric using
IBGP. While troubleshooting, the customer notices that the configuration is missing a configuration parameter.
Which parameter would the customer use to solve this problem?

A. accept-remote-nexthop
B. multihop
C. advertise-peer-as
D. add-path

Answer: D

NEW QUESTION # 39
You have deployed a VXLAN as shown in the exhibit Leaf1, leaf3, spine1, and spine2 have been configured as VTEPs. Host1 cannot communicate with host2.

Referring to the exhibit, how would you solve this problem?

A. The VLAN ID on the connected to host2 must be changed to VLAN 100
B. A layer 3 VXLAN gateway must be configured on at least on at least one of the devices
C. Host1 and host2 must be placed in the same VRF
D. A DCI connected must be created between the VLANs

Answer: B

NEW QUESTION # 40
You have deployed a multitenant EVPN-VXLAN fabric. You must have the routes in the BLUE VRF show up in the RED VRF. In this scenario, how would you achieve this goal?

A. Configure a VRF import policy on the RED VRF that matches the BLUE VRF route target.
B. Configure the BLUE route target in the RED VRF.
C. Configure a VRF export policy on the BLUE VRF that matches the RED VRF route target.
D. Configure the RED route target in the BLUE VRF.

Answer: A

NEW QUESTION # 41
Referring to the exhibit, which two statements are correct? (Choose two.)

A. Switch01 is a spine device.
B. Switch01 is a leaf device.
C. Seamless EVPN VXLAN stitching is in use.
D. An OTT data center interconnect is in use.

Answer: B,C

NEW QUESTION # 42
Which two statements are true Virtual Chassis? (Choose two.)

A. The request virtual-chassis mode fabric reboot command will set the Virtual Chassis to fabric mode with
similar devices
B. By default, Junos switches are in a mixes mode Virtual Chassis
C. The request virtual-chassis mode fabric reboot command will set the Virtual Chassis to mixed mode.
D. By default, Junos switches are in non-mixed mode virtual chassis.

Answer: B,C

NEW QUESTION # 43
Exhibit.

Referring to the exhibit, which two statements are correct? (Choose two.)

A. There is one tunnel to the remote endpoint.
B. The irb. 0 interface is the remote tunnel endpoint interface.
C. There are two tunnels to the remote endpoint.
D. The source tunnel IP address is 192.168.100.11.

Answer: A,D

NEW QUESTION # 44
You are asked to build a single export policy that can be applied to all devices to advertise only loopback IP addresses in the 172.16.0.0/24 subnet into your EBGP IP fabric. In this scenario, which two solutions would accomplish this task? (Choose two.)