Ultimate Guide to Prepare NS0-592 Certification Exam for Network Appliance NCSE in 2021
Use Real NS0-592 Dumps - Network Appliance Correct Answers updated on 2021
NEW QUESTION 37
You are investigating a CIFS issue at a customer site, but it is unclear which SMB version is being used between the client and the server. The customer has provided you with a packet trace output.
In this scenario, which packet exchange contains information to indicate which SMB version was agreed upon by the client and the server?
- A. Negotiate Protocol RequestNegotiate Protocol Response
- B. Ioct1 Request FSCTL_DFS_GET_REFERRALSIoct1 Response FSCTL_DFS_GET_REFERRALS
- C. Session Setup Request Session Setup Response
- D. Tree Connect Request TreeTree Connect Request Response
Answer: D
NEW QUESTION 38
Click the exhibit button.
Your customer is calling about their MetroCluster environment. They have provided you with the output of the metrocluster interconnect adapter show command.
Referring to the exhibit, which statement is correct?
- A. The InfiniBand interconnect is not used in MetroCluster.
- B. This is a 2-node MetroCluster.
- C. For all MetroCluster configurations, this is expected output.
- D. The InfiniBand cables should be connected in this configuration.
Answer: C
NEW QUESTION 39
Click the exhibit button.
Your customer has severe latency on one of their SATA aggregates. You run the statit -b and statit -e commands to obtain detailed disk statistics.
Referring to the output shown in the exhibit, which disk would be the problem?
- A. 0a.11.19
- B. 0a.13.21
- C. 0a.11.21
- D. 0a.11.23
Answer: A
NEW QUESTION 40
Click the exhibit button.
A customer reports that their system recently began logging an error.
Referring to the exhibit, which two statements are correct? (Choose two.)
- A. The bcomd application is responsible for monitoring the observed behavior.
- B. A user is attempting to restart the ntpd daemon.
- C. The spmd application failed to restart the ntpd daemon.
- D. The ntpd daemon is responsible for time services.
Answer: B,D
NEW QUESTION 41
Which two statements are true about a data volume? (Choose two.)
- A. A data volume can be accessed by a user connected to any SVM.
- B. A data volume can be accessed by a LIF on any node.
- C. An SVM root or root load sharing mirror volume must be present on every node.
- D. A data volume can be moved to any aggregate with space for it in the cluster.
Answer: B,D
NEW QUESTION 42
A customer reports that a takeover has been disabled on an HA pair.
What would be a cause for this to happen?
- A. The HA interconnect is not functioning properly.
- B. The cluster network is not functioning properly.
- C. There is a disk running too hot.
- D. The interface for the hardware assist has become unavailable.
Answer: A
NEW QUESTION 43
Click the exhibit button.
When you log in to a node, a warning is displayed as shown in the exhibit.
Which statement is correct in this scenario?
- A. The partner still hosts the CFO aggregate for the node.
- B. The node cannot communicate with the rest of the nodes in the cluster.
- C. The node root volume was moved to a new aggregate.
- D. One or more RDB db files are damaged due to an internal software error.
Answer: B
NEW QUESTION 44
Click the exhibit button.
A customer notifies you that Active IQ is showing a warning that a broadcast domain in their environment has been configured with ports from multiple VLANs.
Referring to the exhibit, which two statements are correct? (Choose two.)
- A. You should change the LIF service policy to net-intercluster to prevent the LIFs from failing over to the e0M ports.
- B. You should move the e0M ports to a Broadcast Domain that is dedicated to only management traffic.
- C. You should configure e0M so that is tagged on VLAN 40.
- D. A VLAN tag cannot be assigned to the e0M port, so the configuration is acceptable.
Answer: A,C
NEW QUESTION 45
A customer calls you about a performance issue that they experienced over the past few days. They want to know if data collection and root cause analysis (RCA) is possible for this issue. This issue appears to be a one time event.
Which tool would be used to satisfy the customer's request?
- A. perfmon
- B. perfstat
- C. OneCollect
- D. Performance Archive
Answer: C
NEW QUESTION 46
Click the exhibit button.
You have just cabled a new shelf to a FAS8200. Running the system node run -node * sysconfig - a command indicates that multipath HA is configured. However, after running Config Advisor, you receive an error that your cabling is incorrect.
As indicated in the exhibit, which two actions will correct the cabling? (Choose two.)
- A. Move the 0b SAS connection on the bottom controller to 0d on the bottom controller.
- B. Move the 0b SAS connection on the top controller to 0d on the bottom controller.
- C. Move the 0b SAS connection on the top controller to 0d on the top controller.
- D. Move the 0b SAS connection on the bottom controller to 0d on the top controller.
Answer: A,C
NEW QUESTION 47
A customer reports that OnCommand Performance Manager shows that the workload on node-02 in a 4-node cluster has increased to a level that is higher than the threshold. The customer wants to avoid this issue becoming a performance problem.
Which two actions would result in achieving this goal? (Choose two.)
- A. Use the storage aggregate scrub command to verify the parity on the busy aggregates.
- B. Physically move the shelf to another node that is less utilized.
- C. Use the volume move command to move one or more volumes to another aggregate that is owned by another node that is less utilized.
- D. Use the storage aggregate relocation command to offload an aggregate to its partner.
Answer: B,C
NEW QUESTION 48
A customer complains that the copy offload does not work when copying large file from a Windows 8 client between the CIFS shares that are hosted on the same ONTAP cluster.
What are two reasons for this problem? (Choose two.)
- A. The source and target volumes reside on different cluster nodes.
- B. The client should be using Windows 10 for ODX support.
- C. Deduplication is not enabled on the destination volume.
- D. SMB 3.0 disabled on the CIFS SVM.
Answer: C,D
NEW QUESTION 49
You configured iSCSI multipathing on a Windows host to a 2-node ONTAP cluster so that you can attach to some LUNs. You see that the host logging in to both iSCSI LIFs in the ONTAP cluster, and you notice that the igroup is correctly set. After you open Disk Management and rescan for disks, the NetApp LUNs do not show up.
In this scenario, what should be performed to enable the LUNs to be visible to the Windows host?
- A. Configure the ONTAP nodes for HA and try scanning again.
- B. Configure the SVM for FCP and try scanning again.
- C. Set up LUN mapping and try scanning again.
- D. Set up Selective LUN Mapping (SLM) and try scanning again.
Answer: D
NEW QUESTION 50
Click the exhibit button.
A storage administrator reports that when they enabled Vscan, they began receiving reports of CIFS users having very slow access to all their files. The storage administrator recovered from the issue by disabling Vscan on their SVM. The storage administrator was able to collect perfstat output during the time of the reported slow access, as shown in the exhibit.
In this situation, what is the problem?
- A. The problem was with both Vscan servers 192.168.100.144 and 10.23.23.54.
- B. The problem is on the SVM, as shown in the scan_latency output.
- C. Vscan server 192.168.100.144 was slower than Vscan server 10.23.23.54 in completing Vscan requests.
- D. Vscan server 10.23.23.54 was slower than Vscan server 192.168.100.144 in completing Vscan requests.
Answer: C
NEW QUESTION 51
Click the exhibit button.
Referring to the exhibit, which change is required to enable the CIFS Autolocation function for the Users share?
- A. Modify the CIFS server's option to enable SMB multichannel.
- B. Re-create the LIFs to allow both CIFS and NFS protocols.
- C. Change the CIFS share's Symlink Properties parameter to symlinks.
- D. Edit the CIFS share's properties to remove the changenotify property.
Answer: C
NEW QUESTION 52
Click the exhibit button.
A customer is reporting that numbers in the statistics volume show command output appear to be incorrect.
Referring to the exhibit, which statement is correct?
- A. The problem is due to a difference in operation size.
- B. There are operation types that are not listed in the output.
- C. A case with NetApp should be raised to find the root cause.
- D. Perfstat should be used to explain the behavior.
Answer: A
NEW QUESTION 53
A customer reports that a LUN is offline because the volume is out of space even though the space-reserve parameter is configured to enabled on the LUN.
Which two statements are correct in this scenario? (Choose two.)
- A. Deduplication is inflating the LUN when it is brought online.
- B. The volume has snapshots.
- C. The containing aggregate is thin-provisioned.
- D. The fractional reserve is set to 0%.
Answer: B,C
NEW QUESTION 54
You have a 2-node ONTAP Select HA deployment. In this scenario, which application manages the quorum, if one node fails?
- A. ONTAP Deploy VM
- B. ONTAP Mediator
- C. Tiebreaker
- D. vCenter Server
Answer: A
NEW QUESTION 55
Which statement is correct about the wafliron command?
- A. The wafliron command is used to correct inconsistent WAFL metadata.
- B. The wafliron command is used to correct WAFL i2p inconsistencies.
- C. The wafliron command is used to correct parity inconsistencies.
- D. The wafliron command is used to correct inconsistent user data blocks.
Answer: A
NEW QUESTION 56
Click the exhibit button.
A customer's system reported several errors. There was no disruption, but the customer is concerned about the system's health.
Referring to the exhibit, which statement is true?
- A. One of the IOM modules on shelf 20 has failed.
- B. Storage redundancy is degraded.
- C. One of the switches has failed.
- D. Port 1D on the system has failed.
Answer: B
NEW QUESTION 57
Click the exhibit button.
You are investigating an AutoSupport Disk Redundancy Failed alert. Cluster A lost connectivity to storage bridge BrB1, while cluster B lost connectivity to storage bridge BrA1.
Referring to the exhibit, which three components need investigation? (Choose three.)
- A. FC switch SwA1
- B. FC switch SwB1
- C. storage bridges BrB1
- D. FC switch SwA2
- E. ISL cables
Answer: A,B,E
NEW QUESTION 58
Click the exhibit button.
You are troubleshooting a system in which the customer reports that aggregates on Stack 6c/12b are having slow response tomes from system NETAPP1CLUS-02.
Referring to the exhibit, which two statements are correct? (Choose two.)
- A. PHY 2 is running at six gigabits per second; on system NETAPP1CLUS-02, reseat IOM6 Module A on Shelf 10.
- B. The aggregates have only one PHY running at six gigabits per second on 6c.
- C. The shelf module firmware is downrev; on system NETAPP1CLUS-02, replace IOM6 Module A on Shelf 10.
- D. The aggregates have only PHY at six gigabits per second on 12b.
Answer: B,C
NEW QUESTION 59
......
Network Appliance NCSE -NS0-592 Exam-Practice-Dumps: https://www.exam4tests.com/NS0-592-valid-braindumps.html